Dependable hydraulic brake light switch with 19" long wires and terminals. Includes two washers; compact and easy to install.
Electrical & Ignition

Active filters
Reliable hydraulic brake-light activation with 19" wires and terminals. Includes two washers for installation.
Hydraulic brake light switch with chrome finish, 19" long wires and two washers for easy installation.
In-line resistors for use with LED lighting; includes extra terminals for easy installation.
Self-contained PC-programmable ignition module with single- or dual-fire modes, ten advance curves, adjustable over-rev protection and comprehensive data logging.
Self-contained ignition module fits under the cam cover. Single- or dual-fire operation, ten advance curves, PC-programmable. Not for fuel-injected models. Made in the USA.
Converts inconsistent surges into controlled bursts for stronger ignition, reduces current to 0.1 amp to prevent burned points, and delivers a 50% faster spark voltage rise.
Compact, high-output coil for customs and concealed installation. Works with Dyna 2000 and 3000 series and with aftermarket dwell-control ignitions. Secondary resistance 11.5 ohms. Not for Twin Cam, Dyna "S", DYNA III or earlier.
Powerful 105–118 dB horn; 80 mm diameter; wire extension included.
Heavy-duty Slugger starter assembled in the U.S.A.; low-profile for easy installation.
Comes complete with bearings and drive clutch; fits high-performance and OEM starters.
Delivers full battery voltage to single-fire coil during cranking. Sealed 30 A unit with high-temp housing. Compact 1.5" x 1" x 1" with mounting flange.
No soldering gun required; low-heat solder activates with a heat gun to create a watertight shrink seal. Packs come in a clear jar with barcode-labeled packs for easy counter or service use.