Best sellers

Chrome 40 Spoke Custom Rim — 21x2.15, 40-hole, chrome, requires custom spokes

-€23.66

DRAG SPECIALTIES Chrome 40 Spoke Custom Rim — 21x2.15, 40-hole, chrome,...

Steel rim with rolled edge for added strength. Manufactured in Japan. Rim only.

€66.85 €90.51

Round Sissy Bar for Hardtail Models — 381 mm (15"), fits rigid frames with 10" axle plate spacing, Chrome

-€29.10

DRAG SPECIALTIES Round Sissy Bar for Hardtail Models — 381 mm (15"), fits rigid...

Chrome-plated round sissy bar for hardtail frames; fits axle plates approximately 10" apart.

€82.24 €111.34

Extra Plate Clutch Kit — Steel drive plate, DuPont™ Kevlar® friction

-€34.48

BARNETT Extra Plate Clutch Kit — Steel drive plate, DuPont™ Kevlar®...

Six bonded friction plates, one metal drive plate and heavy-duty springs; increases contact area by ~20%; wet or dry use; Made in USA.

€134.13 €168.61

-€4.20

DRAG SPECIALTIES Acorn Nut Sets — 10-pack, Silver

Individual packs of acorn nuts. Made in the U.S.A.

€11.85 €16.05

-€17.47
Out of Stock

DRAG SPECIALTIES OEM Fuel Gauge — Black face, white readout

OEM-style fuel gauge with clear analog readout and simple installation.

€49.36 €66.83

-€28.29

DRAG SPECIALTIES Alternator Rotor — 12V, 38A

Direct OEM replacement with encapsulated magnets in a reinforced steel shell for enhanced durability and consistent output.

€79.94 €108.23

-€29.36

DRAG SPECIALTIES Ignition Coil — 12 V, 30,000 V, black

Improves starting and high-speed stability, increases peak spark voltage by at least 20%, and helps improve mileage.

€82.95 €112.31

-€23.13

DRAG SPECIALTIES Passenger Foot Peg Mount Kits — Chrome, left and right mounts

Kits include left and right-side mounts with hardware. Accepts most male-mount footpegs.

€65.35 €88.48

-€4.23

DRAG SPECIALTIES Extended Shift Peg — 83 mm (3-1/4"), Black

Extended shift peg designed to absorb vibration; hollow-core neoprene insert cleats. Screws into shifter arm. Sold each.

€11.97 €16.20

Stainless Steel Brake Line Kit — 42 cm, 44 cm, Front/Lower/Upper, Silver clear-coated

-€34.76

DRAG SPECIALTIES Stainless Steel Brake Line Kit — 42 cm, 44 cm,...

Braided brake line kit with chrome steel fittings; made in the U.S.A.

€98.25 €133.01

-€72.88

DRAG SPECIALTIES Clutch Shell — Part 148141

High-quality replacement clutch shell with starter gear; includes center bearing and snap rings.

€205.97 €278.85

-€36.40
Out of Stock

DRAG SPECIALTIES High Performance Oil Pump — High volume, Steel

Improves oil pressure and volume, reduces oil carryover at high rpm, 53mm rotors, die-cast aluminum body with high-strength steel gears. Fits stock and aftermarket cam support plates; not compatible with Screaming Eagle cam plate.

€102.95 €139.35

Custom Gas Tank — 11.4 L (3 US gal), tunnel 3", 20" L, 11" W, raw

-€49.54

DRAG SPECIALTIES Custom Gas Tank — 11.4 L (3 US gal), tunnel 3", 20" L, 11" W, raw

TIG-welded custom gas tank with chrome mounting hardware; deep tunnel and approximate 23" tab spacing; vented cap sold separately; must be sealed before use.

€140.00 €189.54

Tough-Claw™ Mount with Level Cup™ Drink Holder — Clamp 5/8"–1-1/2", fits 2-1/2"–3-1/2", Black

-€9.50

RAM MOUNTS Tough-Claw™ Mount with Level Cup™ Drink Holder — Clamp...

High-strength composite and stainless steel clamp mount with Level Cup™ self-leveling drink holder; clamps 5/8"–1-1/2", fits 2-1/2"–3-1/2".

€36.97 €46.47

Torque™ Handlebar/Rail Mount Base with 1" Ball — Fits 19 mm (3/4"), 22 mm (7/8"), 25.4 mm (1")

-€5.12

RAM MOUNTS Torque™ Handlebar/Rail Mount Base with 1" Ball — Fits 19 mm...

Low-profile handlebar and rail mount secures personal electronics and small accessories. Nylon-insert locknuts and sizing inserts prevent loosening and protect the rail.

€19.87 €24.99

Can Bus Handlebar Control Module — 48" harness, left mount, chrome

-€35.42

DRAG SPECIALTIES Can Bus Handlebar Control Module — 48" harness, left mount,...

IP66-rated handlebar control module with included switch and wire harness. Not for use with Softail models that feature cruise control.

€100.10 €135.52

-€6.13

DRAG SPECIALTIES OEM-Style Lever — Clutch, Hydraulic, Polished Silver

OEM-style control lever designed to fit stock hand controls for a direct replacement.

€17.32 €23.45

-€1.93

RAM MOUNTS Ball Adapter with AMPS Plate — 1" ball, AMPS 1.5" x 1.188", Black

1" B-size rubber ball on a 2" x 1.7" square base with four pre-drilled holes forming the 1.5" x 1.188" AMPS pattern.

€7.51 €9.44

-€2.25

RAM MOUNTS Mount Adapter — Black, Ball

Marine-grade construction and corrosion-resistant finish
1" rubber ball
Predrilled base holes for multiple mount options

€8.76 €11.01

$Double Socket Arm with Swivel — 25.4 mm (1\") handlebar, Black$

-€5.65

RAM MOUNTS Double Socket Arm with Swivel — 25.4 mm (1\") handlebar, Black

High-strength composite double 1" ball-socket arm with 360° center rotation and 180° swivel; rubber ball ends and central pivot for exceptional adjustability. 5" overall length.

€21.94 €27.59

-€67.98

DRAG SPECIALTIES 1-1/4" Buffalo T-Bar — 1-1/4" diameter, 30" width, black gloss

Comfort-oriented T-bar handlebar. Optional gauge mounts sold separately. Made in the U.S.A. Not for use with stock risers on 883C/1200C models. Compatible with hydraulic clutch controls.

€192.14 €260.12

Showing 211-231 of 231 item(s)

shop by category

Home

Best sellers

Contact us

Products

Our company

shop by category

Home  

Best sellers

Home