Electrical & Ignition

Wire Harness H4 for 7-inch Round Headlight — J.W. SPEAKER, 8200411

-€6.72

J.W. SPEAKER Wire Harness H4 for 7-inch Round Headlight — J.W. SPEAKER,...

Necessary harness to install most aftermarket 7-inch H4 headlights. Includes four sealed solder butt connectors. Made in the U.S.A.

€26.48 €33.20

Heat-Shrink Solderless Wire Connector Kit/Refill — 12–10, 16–14, 22–18, 26–24 AWG, assorted colors

-€8.46

K&S TECHNOLOGIES Heat-Shrink Solderless Wire Connector Kit/Refill — 12–10,...

No soldering gun required; low-heat solder activates with a heat gun to create a watertight shrink seal. Packs come in a clear jar with barcode-labeled packs for easy counter or service use.

€23.84 €32.30

Solderless Wire Connectors — 20-pack, White

On sale!
-€10.94

K&S TECHNOLOGIES Solderless Wire Connectors — 20-pack, White

Solderless splices using low-heat solder that melts with a heat gun and creates a watertight shrink-tube seal.

€30.91 €41.85

$Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black$

On sale!
-€3.11

DEI Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black

Professional-grade high-temp shrink tubing with 3:1 shrink ratio; forms a water-tight seal; heat to apply (120–180°F).

€12.10 €15.21

$Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black$

On sale!
-€19.06

DEI Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black

Professional heat-shrink tubing, 3:1 shrink ratio, water-tight seal and wide operating temperature range.

€74.05 €93.11

$Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black$

On sale!
-€20.97

DEI Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black

Professional-grade high-temperature shrink tubing with 3:1 shrink ratio, water-tight sealing, and broad operating range for wire and splice protection.

€81.43 €102.40

Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

On sale!
-€27.82

DEI Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

Professional-grade shrink tubing with 3:1 shrink ratio for water-tight seals; operates from -67°F to 275°F. Apply with heat gun at 120°F–180°F.

€108.03 €135.85

Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

On sale!
-€40.96

DEI Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

Professional-grade, military-spec polyolefin shrink tubing; 3:1 shrink ratio; seals to 33% of original diameter; operating range -67°F to 275°F; apply heat at 120°F–180°F; Made in USA.

€159.09 €200.05

Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

On sale!
-€17.40

DEI Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

Professional-grade military-spec polyolefin heat-shrink tubing with 3:1 shrink ratio; protects against dirt, dust and solvents. Operates -67°F to 275°F; apply with a heat gun at 120°F–180°F.

€67.57 €84.97

-€38.92

DYNATEK 12 V Ignition Coil — Black

Industry-standard 12 V coil with 35,000 V spark energy; fits Dyna systems. Not for Twin Cam applications.

€151.34 €190.26

-€22.89

DYNATEK-HARLEY Dual Output HD Coil 3 Ohm — 12V, 3.0 ohm, Green

Industry-standard dual-output coil for Dyna ignition systems. Not for Twin Cam applications. Made in the U.S.A.

€89.00 €111.89

-€36.28

DYNATEK-HARLEY Twin Fire II Miniature 3 Ohm Coil — 3.0 ohm, 12V, Black

Compact, sealed ignition coil offering high-voltage output and peak gap current over 50 mA. Made in the U.S.A.

€141.13 €177.41

-€15.58

TERRY COMPONENTS Starter Solenoid Repair Kit — 12V

Includes plunger assembly, contacts and spring. Made in the USA.

€44.05 €59.63

Starter Drive Clutch — 1.4 kW, P/N 550100

-€30.29

TERRY COMPONENTS Starter Drive Clutch — 1.4 kW, P/N 550100

Comes complete with bearings and drive clutch. Suitable for high-performance or OEM starters.

€117.80 €148.09

Electronic Ignition System — Black, dual fire

-€27.46

DYNATEK-HARLEY Electronic Ignition System — Black, dual fire

Self-contained ignition system with Hall Effect sensors. Improves timing less than three degrees, extends plug life, and eliminates points and condensers. Easy to install; requires a 5 ohm aftermarket coil for use with Dyna S and is not recommended with OEM coils.

€106.82 €134.28

Single-Fire Electronic Ignition System — Single-fire, electronic, black/gray

-€38.91

DYNATEK-HARLEY Single-Fire Electronic Ignition System — Single-fire,...

Fires front and rear cylinders independently for more precise timing, improved starting, reduced vibration and increased power. Not for fuel-injected models. Requires special Dyna coils and, on 84-up Harley-Davidsons, an advance weight mechanism.

€151.32 €190.23

-€45.36

DYNATEK-HARLEY Ignition and Coil Kit — Electronic ignition, Black

Complete ignition and coil kit used in drag and road racing; high-voltage coils and retained factory advance curve. Not for fuel injected models.

€176.41 €221.77

-€68.67

DYNATEK-HARLEY Ignition and Coil Kit — Black

Complete ignition and coil kit used by top racers; coils produce over 30,000 V. Housed Dyna S maintains factory advance curve. Not for fuel-injected models.

€267.02 €335.69

-€5.72

DYNATEK Universal 8 mm Suppression Plug Wire Kit — 48"

High-grade suppression core wires; two cut-to-length leads for up to four cylinders. Made in the U.S.A. Not for Twin Cam or '04-'15 XL.

€22.25 €27.97

-€2.16

K&S TECHNOLOGIES 12V Economy Horn — 12V, 69.9 mm, Black

Compact electric horn that adds style and safety and mounts almost anywhere.

€6.10 €8.26

-€2.14

K&S TECHNOLOGIES 12V Economy Horn — 69.9 mm (2-3/4"), Chrome

Add style and safety to your bike. Sized to mount almost anywhere.

€6.03 €8.17

-€2.33

K&S TECHNOLOGIES Spark Plug Cap — 14 mm, terminal nut, 90°, Black

Includes resistor cover and both end rubber caps for secure insulation and terminal protection.

€6.57 €8.90

-€38.92

DYNATEK 12 V Ignition Coil — Green, pair

Industry-standard ignition coil with 35,000 V spark energy, compatible with Dyna ignition systems. Not for Twin Cam applications.

€151.34 €190.26

-€38.92

DYNATEK 12 V Ignition Coil — 35,000 V, Green

Industry-standard high-energy spark; fits Dyna ignition systems; made in the USA; not for Twin Cam applications.

€151.34 €190.26

-€70.39

DYNATEK-HARLEY Two-Stage Rev Limiter for EFI — Black

Precisely controls over-revving and adjustable launch limit from 2,500 to 6,250 rpm in 250 rpm increments. Made in the U.S.A. Not for Twin Cam.

€273.69 €344.08

-€111.44

TERRY COMPONENTS Starter Motor — 12V, 1.4 kW

Rebuilt Nippondenso starter with upgraded internal components for extended service life.

Dyno tested and assembled in the U.S.A.

€433.38 €544.82

-€111.44

TERRY COMPONENTS Starter Motor — 12V, 1.4 kW, Chrome

Heavy-duty Nippondenso starter assembled in the USA and dyno-tested for reliable starting performance.

€433.38 €544.82

-€106.30

TERRY COMPONENTS Starter Motor — 12V, 1.4 kW, Black

Nippondenso starter assembled in the United States with heavy-duty components and precision testing for dependable starts.

€413.38 €519.68

-€272.68

TERRY COMPONENTS 2.0 kW Starter Motor — 12V, Chrome

Heavy-duty starter with reinforced internals, precision-ground clutch components, CNC billet mounting noses and complete dyno testing. Made in the USA.

€770.60 €1,043.28

-€162.76

TERRY COMPONENTS 2.0 kW Starter Motor — 12V, Black wrinkle

Heavy-duty starter with reinforced solenoid and clutch components, precision-ground parts, CNC billet mounting, and dyno testing for reliable high-torque starts.

€632.91 €795.67

Electrical & Ignition

Contact us

Products

Our company