Electrical & Ignition

Total Control Passing Lamp Harness — 12 V

-€7.26

KURYAKYN Total Control Passing Lamp Harness — 12 V

Keeps passing lamps lit with the high beam; required for Phase 6/Phase 7 LED setups. Plug-and-play installation.

€28.25 €35.51

Aluminum Load Equalizers — 12V, Pair, Black anodized

-€3.27

KURYAKYN Aluminum Load Equalizers — 12V, Pair, Black anodized

Replaces OEM incandescent turn signals with low-draw LEDs; includes heat-shrink butt connectors and a heat-dissipating extruded housing. 100W — 6Ω rating. In most cases allows all four signals to be upgraded.

€12.74 €16.01

-€17.76

ANDREWS Supervolt 12 V Ignition Coil — 12V, 30,000V, Black

Original Andrews replacement coil with classic styling and increased spark performance. Made in the U.S.A.

€69.08 €86.84

-€17.76

ANDREWS Supervolt 12 V Ignition Coil — 30,000V, Red

Classic-look replacement ignition coil that boosts spark output and improves throttle response. Made in the U.S.A.

€69.08 €86.84

Spark Plug Head Bolt Cover — Chrome, Silver

-€18.21

KURYAKYN Spark Plug Head Bolt Cover — Chrome, Silver

Stepped and slotted design complements the engine; faceted edges reflect light. Easy to install for a clean, finished look.

€70.78 €88.99

-€24.01

KURYAKYN Mach 2™ Horn Cover — Chrome, Black

Perfect complement to the Mach 2™ air cleaner; replaces the stock "cowbell" horn cover for a cleaner look.

€93.36 €117.37

-€212.73

TERRY COMPONENTS Slugger 1.8kW High-Torque Starter Motor — 12 V, Black

Heavy-duty Slugger starter assembled in the U.S.A.; low-profile for easy installation.

€601.18 €813.91

-€21.60

KURYAKYN Starter Solenoid Cover — Chrome

Protects the starter solenoid and related wiring; direct-fit with stock starter end cover.

€83.99 €105.59

-€16.06

TERRY COMPONENTS Late Starter Output Shaft Gear — Starter Output Shaft, 555160

Quality OEM replacement gear for late starter clutches.

€45.39 €61.45

-€61.61

TERRY COMPONENTS Starter Drive Clutch — 1.5 kW

Comes complete with bearings and drive clutch; fits high-performance and OEM starters.

€174.10 €235.71

-€20.64

TERRY COMPONENTS Starter Brush Holder — 12V

High-quality OEM replacement starter brush holder for reliable starting and long service life.

€58.34 €78.98

-€132.78

TERRY COMPONENTS Slugger 1.8kW High-Torque Starter Motor — 12V, Chrome

Heavy-duty starter assembled in the U.S.A.; superior windings, thicker commutator, high-tolerance clutch, static balanced, low-profile for easy installation.

€516.38 €649.16

-€132.78

TERRY COMPONENTS Slugger 1.8kW High-Torque Starter Motor — 12V, Black

Heavy-duty Slugger starter assembled in the U.S.A.; superior windings and clutch for smoother, more reliable starting. Low-profile for easy installation.

€516.38 €649.16

-€108.72

TERRY COMPONENTS Rebuild Kit — 12V, Unfinished

Rebuild kit for electric reverse motors with all-new components and step-by-step instructions.

€422.81 €531.53

-€152.02

TERRY COMPONENTS 2.0 kW Starter Motor — 12 V, Chrome

High-torque replacement starter with precision-ground components, special lubrication and dyno-tested reliability. Made in the USA.

€591.22 €743.24

-€17.37

KURYAKYN Regulator Cover — Chrome

Two-piece stamped cover fits the stock regulator; open, vented design; decorative fasteners; room inside for lights.

€67.56 €84.93

$Electronic Throttle Control Extension — 20 cm (8\"), throttle-by-wire, Black$

-€13.06

BARNETT Electronic Throttle Control Extension — 20 cm (8\"),...

Enables easy handlebar height changes on bikes with electronic throttle control. OEM-type connectors for a reliable fit. Made in the USA.

€50.78 €63.84

-€13.11

BARNETT Electronic Throttle Control Extension — 12" cable

Allows easy handlebar height changes on electronic throttle models.
OEM-type connectors for plug-and-play installation.
Made in the USA.

€50.95 €64.06

-€3.81

KURYAKYN Prism+ Light Wiring Connector — Y-Cable, Short

Relay loop connector that returns the signal to the Bluetooth controller for reliable light operation.

€14.83 €18.64

$Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black$

-€4.76

DEI Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black

Professional-grade high-temp shrink tubing with 3:1 shrink ratio; forms a water-tight seal; heat to apply (120–180°F).

€10.45 €15.21

$Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black$

-€29.10

DEI Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black

Professional heat-shrink tubing, 3:1 shrink ratio, water-tight seal and wide operating temperature range.

€64.01 €93.11

$Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black$

-€32.02

DEI Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black

Professional-grade high-temperature shrink tubing with 3:1 shrink ratio, water-tight sealing, and broad operating range for wire and splice protection.

€70.38 €102.40

Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

-€42.47

DEI Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

Professional-grade shrink tubing with 3:1 shrink ratio for water-tight seals; operates from -67°F to 275°F. Apply with heat gun at 120°F–180°F.

€93.38 €135.85

Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

-€62.54

DEI Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

Professional-grade, military-spec polyolefin shrink tubing; 3:1 shrink ratio; seals to 33% of original diameter; operating range -67°F to 275°F; apply heat at 120°F–180°F; Made in USA.

€137.51 €200.05

$Hi-Temp Shrink Tubes — 3.2 mm (1/8\"), 15.2 m (50'), Black$

-€20.21

DEI Hi-Temp Shrink Tubes — 3.2 mm (1/8\"), 15.2 m (50'), Black

Professional-grade polyolefin shrink tubing with 3:1 ratio for wire insulation, strain relief and a water-tight seal across a wide temperature range.

€44.38 €64.59

Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

-€26.57

DEI Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

Professional-grade military-spec polyolefin heat-shrink tubing with 3:1 shrink ratio; protects against dirt, dust and solvents. Operates -67°F to 275°F; apply with a heat gun at 120°F–180°F.