Electrical & Ignition
Active filters
Compact control module for run, brake and turn lights. Compatible with LED, halogen and incandescent bulbs.
In-line resistors for use with LED lighting; includes extra terminals for easy installation.
Turns stock or custom turn signals into running and brake lights while preserving turn signal function. Built-in load equalizer, plug-in installation, made in the USA.
Stops erratic front turn-signal blinking. Compatible with halogen and LED front signals, solid-state waterproof module, parade-safe with no heat, works with OEM alarm/turn-signal modules, made in the USA.
Eliminates erratic blinking; plug‑in module for use with OEM alarm/TSM; solid-state sealed design; one module per signal pair.
Restores correct flash rate for halogen and LED turn signals; one module required per pair.
Separates running and brake lights from flashing turn signals; includes rear fender harness to replace stock wiring.
Powerful 105–118 dB horn; 80 mm diameter; wire extension included.
Delivers full battery voltage to single-fire coil during cranking. Sealed 30 A unit with high-temp housing. Compact 1.5" x 1" x 1" with mounting flange.
- Allows easy handlebar height changes on electronic throttle models.
- OEM-type connectors for plug-and-play installation.
- Made in the USA.
No soldering gun required; low-heat solder activates with a heat gun to create a watertight shrink seal. Packs come in a clear jar with barcode-labeled packs for easy counter or service use.