Electrical & Ignition (3)

-€61.61

TERRY COMPONENTS Starter Drive Clutch — 1.5 kW

Comes complete with bearings and drive clutch; fits high-performance and OEM starters.

€174.10 €235.71

-€20.64

TERRY COMPONENTS Starter Brush Holder — 12V

High-quality OEM replacement starter brush holder for reliable starting and long service life.

€58.34 €78.98

-€132.78

TERRY COMPONENTS Slugger 1.8kW High-Torque Starter Motor — 12V, Chrome

Heavy-duty starter assembled in the U.S.A.; superior windings, thicker commutator, high-tolerance clutch, static balanced, low-profile for easy installation.

€516.38 €649.16

-€132.78

TERRY COMPONENTS Slugger 1.8kW High-Torque Starter Motor — 12V, Black

Heavy-duty Slugger starter assembled in the U.S.A.; superior windings and clutch for smoother, more reliable starting. Low-profile for easy installation.

€516.38 €649.16

-€9.85

COMP CAMS Fast Start Boost Relay — 12V

Delivers full battery voltage to single-fire coil during cranking. Sealed 30 A unit with high-temp housing. Compact 1.5" x 1" x 1" with mounting flange.

€27.89 €37.74

-€108.72

TERRY COMPONENTS Rebuild Kit — 12V, Unfinished

Rebuild kit for electric reverse motors with all-new components and step-by-step instructions.

€422.81 €531.53

-€152.02

TERRY COMPONENTS 2.0 kW Starter Motor — 12 V, Chrome

High-torque replacement starter with precision-ground components, special lubrication and dyno-tested reliability. Made in the USA.

€591.22 €743.24

Posi-Lock® Wire Connector — 9-pack, 24-18 AWG, Red

-€2.81

CUSTOM DYNAMICS Posi-Lock® Wire Connector — 9-pack, 24-18 AWG, Red

Superior connection compared to crimping. Wire ends lock between opposing cone shapes when hand tightened.

€9.86 €12.67

Posi-Lock® Wire Connector — 6-pack, 24–18 AWG, Red

-€2.81

CUSTOM DYNAMICS Posi-Lock® Wire Connector — 6-pack, 24–18 AWG, Red

Provides a superior alternative to crimping; locks wire ends between opposing cones when hand tightened for a secure mechanical connection.

€9.86 €12.67

-€2.19

CUSTOM DYNAMICS Wiring Cage Clamp — 3-pin, 20 A

Compact spring-clip connector for joining multiple wires; accepts up to five 24 AWG wires per port.

€6.70 €8.89

-€2.64

CUSTOM DYNAMICS Mini ATC Fuse Holder — 3 A, 5-pack, Black, Red

Waterproof-boot mini fuse kit with five holders and pre-installed 3 amp fuses.

€9.26 €11.90

-€4.85

CUSTOM DYNAMICS TruBEAM® Headlamp Adapter Harness — Fits H4

Required when replacing stock dual-halogen headlamps with an LED headlamp or any other H4-based headlamp. Provides plug-and-play connection.

€17.02 €21.87

$Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black$

-€4.76

DEI Hi-Temp Shrink Tubes — 25.4 mm (1\"), 122 cm (4\'), Black

Professional-grade high-temp shrink tubing with 3:1 shrink ratio; forms a water-tight seal; heat to apply (120–180°F).

€10.45 €15.21

$Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black$

-€29.10

DEI Hi-Temp Shrink Tubes — 9.5 mm (3/8\"), 15.2 m (50'), Black

Professional heat-shrink tubing, 3:1 shrink ratio, water-tight seal and wide operating temperature range.

€64.01 €93.11

$Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black$

-€32.02

DEI Hi-Temp Shrink Tubes — 12.7 mm (1/2\"), 15.2 m (50'), Black

Professional-grade high-temperature shrink tubing with 3:1 shrink ratio, water-tight sealing, and broad operating range for wire and splice protection.

€70.38 €102.40

Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

-€42.47

DEI Hi-Temp Shrink Tubes — 16.8 mm (11/16"), 15.2 m (50'), Black

Professional-grade shrink tubing with 3:1 shrink ratio for water-tight seals; operates from -67°F to 275°F. Apply with heat gun at 120°F–180°F.

€93.38 €135.85

Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

-€62.54

DEI Hi-Temp Shrink Tubes — 25.4 mm (1") diameter, 15.2 m (50')

Professional-grade, military-spec polyolefin shrink tubing; 3:1 shrink ratio; seals to 33% of original diameter; operating range -67°F to 275°F; apply heat at 120°F–180°F; Made in USA.

€137.51 €200.05

$Hi-Temp Shrink Tubes — 3.2 mm (1/8\"), 15.2 m (50'), Black$

-€20.21

DEI Hi-Temp Shrink Tubes — 3.2 mm (1/8\"), 15.2 m (50'), Black

Professional-grade polyolefin shrink tubing with 3:1 ratio for wire insulation, strain relief and a water-tight seal across a wide temperature range.

€44.38 €64.59

Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

-€26.57

DEI Hi-Temp Shrink Tubes — 6.4 mm (1/4"), 15.2 m (50'), Black

Professional-grade military-spec polyolefin heat-shrink tubing with 3:1 shrink ratio; protects against dirt, dust and solvents. Operates -67°F to 275°F; apply with a heat gun at 120°F–180°F.

€58.40 €84.97

-€17.41

TECHNORESEARCH Data Cable — Harley-Davidson®, Red

Data Cable compatible with TR4 VCMs (Centurion, Maximus and Alaris); required for programming '21 and '22 models.

€25.16 €42.57

-€6.71

CUSTOM DYNAMICS TriBar Eliminator Harness — 20 cm (8 in), for Harley-Davidson®

Plug-and-play harness that removes the factory lower TriBar shell and powers the rear OEM turn signal bar.

€26.08 €32.79

-€8.44

CUSTOM DYNAMICS Rear Fender Adapter — Harley-Davidson®

Direct plug-in adapter for rear fender swaps; connects to the OEM under-seat and rear lighting harnesses for plug-and-play installation.

€32.80 €41.24

-€8.44

CUSTOM DYNAMICS Rear Fender Adapter — for Harley-Davidson®

Plugs into the OEM harness under the seat and mates with the OEM rear lighting harness for plug-and-play swaps. No splicing required.

€32.80 €41.24

3 In 1 OBD TR4 Cable — 4-pin, 6-pin & OBD connectors, fits TR4 VCMs '01–'23, Harley Davidson®

-€27.70

TECHNORESEARCH 3 In 1 OBD TR4 Cable — 4-pin, 6-pin & OBD connectors, fits TR4...

Combines old and newer data port styles. Includes 4-pin, 6-pin and OBD connectors; compatible with '01–'23 models. Made in the USA. For use with TR4 VCMs only.

€107.50 €135.20

-€12.14

TECHNORESEARCH Adapter Cable — 12V, Black

Cable for directly sourcing power between the battery and the TRO controller.

€48.86 €61.00

Security Can Retrieval Cable — 12V, Black, Red

-€12.14

TECHNORESEARCH Security Can Retrieval Cable — 12V, Black, Red

CAN security retrieval cable for upgrading VCM-TR4 dealer pack and Centurion Super Pro Plus; includes fuse and fuse holder. Works only with #3807-0499 and #1020-2851.

€48.86 €61.00

SMART Controller Brake Y-Harness — For Harley Davidson®, Black

-€6.82

CUSTOM DYNAMICS SMART Controller Brake Y-Harness — For Harley Davidson®, Black

Plug-and-play Y-harness that feeds brake signal to 3-wire (red non-sequential) lighting products for use with the Smart Turn Signal Controller and 1157 dual-color rear signals.

€26.55 €33.37

-€7.12

CUSTOM DYNAMICS Throttle-By-Wire Extension Kit — 30.5 cm (12"), Black

Pre-cut lengths for easy extension of OEM throttle wires; color-matched Molex-terminated wiring; plug-and-play installation.

€27.74 €34.86

-€7.12

CUSTOM DYNAMICS Throttle-By-Wire Extension Kit — 4" wire length, Harley Davidson®

Pre-cut, color-matched Molex-terminated leads for quick plug-and-play extension of OEM throttle-by-wire wiring during handlebar installs.

€27.74 €34.86

-€4.11

CUSTOM DYNAMICS Shark Demon® Single Lamp Wire Harness — SD2-UNV-HARN

Wire harness that connects the Shark Demon® headlight to vehicle high beam, low beam, and ground.

€15.99 €20.10

Contact us

Products

Our company