Subcategories
Active filters
Weatherproof front-panel SAE power socket for harsh environments. Front-only installation; fits a Ø1"/25 mm hole. Remains flexible at very low temperatures.
- Permanent SAE lead with integrated lithium battery monitor.
- Two automatic modes: charge level and charging system test.
- Three LEDs plus overcharge warning; low standby draw.
Fully automatic six-step 12 V/12.8 V solar charge controller and battery monitor; smart 5 A charging for 12 V batteries. Compatible with 10–60 W solar panels.
- GOLD series 9-step automatic charger and maintainer for power-sport batteries.
- Quad programs: direct, live-socket (optional O-19 cable), or BMW CAN-bus charging with automatic activation.
- Smart desulphation, low-voltage recovery and BMS reset for LFP, plus S.O.H. testing.
- Safe to leave connected, full electronic protection, energy-saving standby, and IP54 weatherproof.
SAE to DIN/AUTO 12 V adapter with LED state-of-charge monitor; fits 21 mm AUTO and 12 mm DIN sockets; weatherproof sealing cap; supports AGM and LFP; operates to -40°C/-40°F; two automatic modes.
Onboard charger and monitor for charging devices and protecting your parked battery.
Weatherproof portable dual USB charger with in-line 180° BIKE plug for BMW, Triumph and Ducati Multistrada. Fast, safe charging for USB‑A and USB‑C devices with automatic one-hour shutoff to protect the vehicle battery.
Automatic diagnostic charger for four batteries with independent banks; activates new batteries, saves deeply discharged units, and runs state‑of‑health tests. Replaceable output cords and service‑oriented design.
MagCode® 12 V magnetic connector clip cable with 75 cm nylon-sleeved 16 AWG cable, SAE termination, and rubber in-line seal.
Short-circuit proof magnetic connection with sealing cap and weather-rated insulation for dependable outdoor use.
- Provides better leverage to push, pull or twist springs into place
- Looped handle for a comfortable grip
- Made in the U.S.A.
Simplifies installation of rear suspension springs for home or shop use. Made in the U.S.A.
Special grinding wheel for sharpening carbide runners and studs. Fits 1/2" or 1" arbor; 1" x 6".
On-machine sharpening wheel for runners and studs; fits most hand grinders and features a 7/8" mounting handle.