Electrical & Ignition

Active filters
Enables custom handlebar switches; plugs into the factory harness under the fuel tank. Does not work with keyless ignition.
Protects factory turn signal module when adding a trailer; plug-and-play inline unit with fuse and holder included.
- Self-contained unit fits under the cam cover for a clean look.
- Single-fire operation to zero rpm; supports single or dual-fire setups.
- Ten advance curves, adjustable rev limit and retard for forced induction.
- VOES indicator, built-in tach driver, and extensive data logging.
- PC-programmable; programming kit required for downloads and full programming.
Plug-in PC-programmable digital ignition for late-model Harleys. Four advance curves, four rev limiter settings (6000–7500 rpm), separate tach output, and diagnostic LED. Not for fuel-injected models.
PC-programmable digital ignition module that replaces late-model electronic advance systems. Allows custom advance curves, adjustable rev limits (6000–7500 rpm), separate tach output, and includes a diagnostic LED. Not for fuel-injected models.
- Two independent adjustable rev limiters (launch and high-side)
- Launch: 2500–6250 RPM; high-side: 5500–9250 RPM
- Holds launch within ±50 RPM
- Direct plug-in connection at the coil
Compact, high-output ignition coil for Dyna 2000/3000 and dwell-controlled ignitions. Not for Twin Cam or older Dyna generations.
Reliable dual-output ignition coil for aftermarket and OEM applications. Made in the USA.
Extended harness simplifies handlebar swaps. Color coded for OEM match. Measures 36". Made in the U.S.A.
Sealed Deutsch DT connector components for rebuilding and repairing wiring harnesses. Sold each.
Organizes Deutsch pins and plugs in one kit. Made in the U.S. Includes a storage bin, 100 open-style pins, 100 open-style stamp sockets, and receptacles: four each of 2-, 3-, 4-, 8- and 12-pin; 6-pin (6 per kit).
Non-waterproof replacement connectors used on factory models. Made in the U.S.A.
Eight high-quality connectors (four of each common style) for reliable electrical repairs and custom wiring. Made in the USA.
Connects intake and oxygen sensors. Includes terminal ends and wire seals for a secure, weather-resistant connection.
Complete ready-to-install wiring extension kit with heat shrink, color-matching wire and Molex male/female terminals for OEM H‑D switches.
Complete handlebar wire extension kit with crimped Molex terminals, heat shrink and color-matching wire. Made in the U.S.A.
Complete ready-to-install kit to extend OEM H-D handlebar switch wiring. Harnesses with male and female Molex terminals, heat shrink, and color-matching wire. Made in the U.S.A.
Safe, color-coded extension harness for taller handlebars; plug-and-play on compatible models. Made in the U.S.A.