Electrical & Ignition

Active filters
Enables custom handlebar switches; plugs into the factory harness under the fuel tank. Does not work with keyless ignition.
Protects factory turn signal module when adding a trailer; plug-and-play inline unit with fuse and holder included.
- Self-contained unit fits under the cam cover for a clean look.
- Single-fire operation to zero rpm; supports single or dual-fire setups.
- Ten advance curves, adjustable rev limit and retard for forced induction.
- VOES indicator, built-in tach driver, and extensive data logging.
- PC-programmable; programming kit required for downloads and full programming.
PC-programmable plug-in ignition upgrade with four advance curves, selectable rev limits, diagnostic LED and separate tach output.
Plug-in PC-programmable digital ignition for late-model Harleys. Four advance curves, four rev limiter settings (6000–7500 rpm), separate tach output, and diagnostic LED. Not for fuel-injected models.
PC-programmable digital ignition module that replaces late-model electronic advance systems. Allows custom advance curves, adjustable rev limits (6000–7500 rpm), separate tach output, and includes a diagnostic LED. Not for fuel-injected models.
- Two independent adjustable rev limiters (launch and high-side)
- Launch: 2500–6250 RPM; high-side: 5500–9250 RPM
- Holds launch within ±50 RPM
- Direct plug-in connection at the coil
Compact, high-output ignition coil for Dyna 2000/3000 and dwell-controlled ignitions. Not for Twin Cam or older Dyna generations.
Reliable dual-output ignition coil for aftermarket and OEM applications. Made in the USA.
Quick-fit billet knob cover installs over stock switch knob using double-sided adhesive for a clean, custom look.
Quick-fit ignition switch cover with easy adhesive installation and billet-matching design.
Sealed Deutsch DT connector components for rebuilding and repairing wiring harnesses. Sold each.
Organizes Deutsch pins and plugs in one kit. Made in the U.S. Includes a storage bin, 100 open-style pins, 100 open-style stamp sockets, and receptacles: four each of 2-, 3-, 4-, 8- and 12-pin; 6-pin (6 per kit).
Non-waterproof replacement connectors used on factory models. Made in the U.S.A.
Eight high-quality connectors (four of each common style) for reliable electrical repairs and custom wiring. Made in the USA.
Connects intake and oxygen sensors. Includes terminal ends and wire seals for a secure, weather-resistant connection.
Complete ready-to-install wiring extension kit with heat shrink, color-matching wire and Molex male/female terminals for OEM H‑D switches.
Complete handlebar wire extension kit with crimped Molex terminals, heat shrink and color-matching wire. Made in the U.S.A.