Electrical & Ignition

Active filters
Plug-and-play module that converts Tour-Pak® lights to running, brake and turn signals. Works with LEDs only; increases rear and side visibility.
Easy-to-install adapter for connecting run, brake, turn and ground wires.
Slimline brake light flasher with 10 selectable patterns, sealed weather-tight case and plug-and-play installation.
Slimline brake light flasher with 10 selectable patterns, compatible with stock LED lights, sealed weather-tight case, plug-and-play.
Slimline brake light flasher with 10 selectable strobe patterns, sealed weather-tight case, and plug-and-play installation.
- Converts rear turn signals to run-brake-turn
- Works with LEDs or incandescent bulbs
- Ten brake strobe/flash patterns and ten running light intensities
- Selectable strobe application: center, rear, or both
- Built-in short circuit protection and sealed, weather-tight case
- Replaces run, brake and turn functions on non-CVO '10-'13 FLHX/FLTRX.
- Ten programmable brake strobe functions controlled by a switch.
- Pigtail with Molex SS6 connector plugs into the stock wire harness.
- May require a load equalizer for proper operation.
Enables custom handlebar switches; plugs into the factory harness under the fuel tank. Does not work with keyless ignition.
- Slimline design fits under the seat
- 10 user-selectable flash and strobe patterns
- Works with stock LED lights
- Sealed weather-tight case with electrical protections
- Plug-and-play installation
Slimline brake light flasher with 10 selectable patterns. Works with stock LED lights, sealed weather-tight case, and plug-and-play installation.
Total isolation for lighting and electrical accessories. Short-circuit protected outputs without relays. Ground to isolated outputs with isolated left/right turn, brake, and run/accessory outputs. Plug-and-Play; optional trailer harness #2120-0929.