- Replaces run, brake and turn functions on non-CVO '10-'13 FLHX/FLTRX.
- Ten programmable brake strobe functions controlled by a switch.
- Pigtail with Molex SS6 connector plugs into the stock wire harness.
- May require a load equalizer for proper operation.
Active filters
- Slimline design fits under the seat
- 10 user-selectable flash and strobe patterns
- Works with stock LED lights
- Sealed weather-tight case with electrical protections
- Plug-and-play installation
Slimline brake light flasher with 10 selectable patterns. Works with stock LED lights, sealed weather-tight case, and plug-and-play installation.
Total isolation for lighting and electrical accessories. Short-circuit protected outputs without relays. Ground to isolated outputs with isolated left/right turn, brake, and run/accessory outputs. Plug-and-Play; optional trailer harness #2120-0929.
Isolates and protects all lighting outputs with short-circuit protection and isolated outputs for turn, brake, and run/accessory circuits. Plug-and-play with optional trailer harness available.
Converts rear turn signals to run-brake-turn; works with LED or incandescent bulbs, offers selectable strobe patterns and intensities, sealed and protected.
Plug-and-play 2-pin flasher relay; direct replacement for the stock flasher. Required for LED turn signal conversions. One unit per bike.
Installs into the main wire harness for one pair of Red Plasma Rods™. Plug-and-play.
Installs into the main harness to enable run, turn and brake operation for Dual Color Plasma Rods. Compatible with plug-and-play rods (sold separately).