Active filters
Converts turn signals to auto-cancel and adds 4-way flashers; quick-connect connectors included for an easier installation.
Plug-and-play harness plugs into the OEM circuit board.
One harness needed per taillight.
No cutting or splicing required.
Wire adapters allow installation of ProBeam® Dynamic Strips™ (Part #s 2040-2556, 2040-2558, 2040-2557; sold separately).
Plug-and-play for easy installation.
Installs into the main wire harness for easy hookup of one pair of Red Plasma Rods™ (sold separately).
Plug-and-play installation for fast, reliable wiring.
Alternating brake strobe module with 10 selectable flash/strobe patterns and plug-and-play installation.
- Alternating left-to-right strobe while the horn is active.
- Ten selectable flash and strobe patterns via dial.
- Requires OEM front signals converted to low-current LEDs; plug-and-play.
Snap-on ignition switch cover installs with included two-sided tape for a clean, finished look.
Powerful 105–118 dB horn; 80 mm diameter; wire extension included.
Provides a superior alternative to crimping; locks wire ends between opposing cones when hand tightened for a secure mechanical connection.
Compact spring-clip connector for joining multiple wires; accepts up to five 24 AWG wires per port.
No soldering gun required; low-heat solder activates with a heat gun to create a watertight shrink seal. Packs come in a clear jar with barcode-labeled packs for easy counter or service use.