List of products by brand MAGNUM SHIELDING

Polished braided crossover fuel line with crystal-clear jacket, compression fittings and two seal sizes; made in the USA.

Precision-brazed two-piece front brake kit with PTFE/aramid inner tubing and AN-3 fittings for reduced expansion and a clean, leak-free appearance. Sold per wheel; upper-line options accommodate varied routing.

Two-piece direct-fit design for accurate installation on non-ABS bikes. Crystal clear jacket resists scuffing and discoloration. AN-3 connections for easy fitment. One upper and one lower kit required per side; two kits per bike.

Complete braided cable and brake-line installation kit with hardware and switch wiring extensions; DOT-compliant and assembled in the USA.

Complete installation kit with matching braided cables and brake lines for a finished, reliable setup.

Includes necessary hardware, copper crush washers, and DOT-compliant brake lines; assembled in the USA.

Complete kit with matched braided cables, brake lines, hardware, and switch wiring for handlebar installations using risers.

Complete installation kit with matching braided cables and brake lines. Includes throttle and idle cables or throttle-by-wire extensions, clutch or hydraulic clutch line, brake lines, hardware, washers, and any required switch wiring or turn signal extension. Meets OE specs and DOT FMVSS-106; assembled in the USA.

Complete kit with matching braided cables and brake lines; includes cables, brake lines, hardware, and wiring for seamless installation. DOT FMVSS‑106 compliant and assembled in the USA.

Complete handlebar installation kit with matching braided cables and brake lines; includes hardware and wiring for easy fitment.

Complete kit with matching braided cables and brake lines for a finished installation.

Includes throttle/idle, clutch or hydraulic clutch line, brake lines, washers, hardware and switch wiring.

PTFE/Kevlar® brake construction, DOT FMVSS-106 compliant, assembled in the USA.

Complete installation kit with matching braided cables and brake lines, PTFE/Kevlar brake lines, DOT‑compliant, assembled in USA.

Complete kit with matching Sterling Chromite II® braided cables, brake lines, hardware, and wiring for a clean installation.

PTFE inner tubing with DuPont™ Kevlar® reinforcement and Signature Magnum braids; DOT FMVSS-106 compliant.

Includes throttle-by-wire extensions and options for cable or hydraulic clutch.